Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Converting a Drill Press
-
9th May 2012, 05:29 PM #1Senior Member
- Join Date
- Dec 2008
- Location
- Coffs Harbour
- Posts
- 228
Converting a Drill Press
I apologise in advance if I have put this in the wrong place, but I could find no other.
I have a Craftmaster Drill Press (Gift) that has not been fitted with a wind up table.
My guess is, that if they are available, the rachet bar, and the section to fit the stand pipe would be sufficient to set my press up for easier plate lifting....But then again, I have been wrong before, I think.
The stand pipe is 60mm (neat) and the Craftmaster type # is TCE-13
Any ideas would be most appreciated. I have just sent an email to Carbatech.
Thanks
BB
-
9th May 2012 05:29 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
9th May 2012, 05:47 PM #2
I would lso try Hare and Forbes I think the craftsman range come from either Total Tools or Gasweld which maybe able to help.
-
9th May 2012, 06:04 PM #3
For $80 you could fit an Easy riser Kit, which would solve your problem.
Chris
========================================
Life isn't always fair
....................but it's better than the alternative.
Similar Threads
-
Drill Press vs Normal Drill on stand
By johno_84 in forum HAND TOOLS - POWEREDReplies: 7Last Post: 1st October 2021, 01:55 PM -
new drill press: quill stroke vs drill bit length ?
By bannock in forum GENERAL & SMALL MACHINERYReplies: 2Last Post: 21st June 2008, 09:09 AM