Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
28th July 2011, 09:07 AM #1Member
- Join Date
- Apr 2009
- Location
- New Zealand
- Posts
- 71
Which method should I use to veneer around a subtle angle?
Hello,
I have started construction of a pair of floorstanding loudspeakers and the cabinets have a few quirky angles in them. I want to veneer these with some cherrywood veneer and am wondering about the best method to do this with.
The angle that I think will prove most difficult is 194 degrees. I imagine that the best thing to do would be to attempt to butt the veneers together after having cut the coresponding angles with a veneer knife. (by the way, when would you use a veneer saw over a veneer knife? - is it a speed over accuracy choice?)
However, the problem I think I will come across by butt joining this angle will be that my glueing method - iron-on veneering using titebond II (to reduce the 'creep' issue) - is that the iron may shrink the butt joints apart?
Perhaps I am better to try and layer the two panels veneers over each other and carefully sand by hand? However, this would lose the uniterupted flow of grain in the veneer.
Is it possible just to glue a full sheet over the edge? Perhaps if I scored it from behind - if I could gouge a "V" shape channel in the right place on the back of the veneer so that it folded nicely over the edge... but there are two of these angles on each side of the loudspeakers...
Not very easy to get veneering supplies here in NZ. I have found hideglue and tools, and I can get titebond glues here too. Can't afford a vacuum press setup either.
Here's a picture of the project:
-
28th July 2011 09:07 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
28th July 2011, 11:24 AM #2
These are suggestions only as I have no experiance.
As the box is yet to be assembled, put the veneer on the individual pieces first before final assembly. You might loose a little bit where the join is.
Another thing you might try is to see if the veneer will go around the angle on two smaller pieces with the same angle join. Or smooth the join so the veneer needs to go around a radius rather than an angle.
Looks good so far. Hope it turns out OK.
-
28th July 2011, 01:06 PM #3Member
- Join Date
- Apr 2009
- Location
- New Zealand
- Posts
- 71
Similar Threads
-
Cutter angle for a 12-060 low angle block plane
By scoobs6170 in forum HAND TOOLS - UNPOWEREDReplies: 3Last Post: 22nd February 2009, 09:46 AM -
Having trouble understanding low-angle vs high angle planes
By wsal in forum HAND TOOLS - UNPOWEREDReplies: 4Last Post: 2nd December 2008, 12:04 AM -
Low angle vs. High angle Planing
By silentC in forum HAND TOOLS - UNPOWEREDReplies: 68Last Post: 1st November 2006, 03:56 PM -
Subtle Avatars
By Wood Borer in forum NOTHING AT ALL TO DO WITH WOODWORKReplies: 105Last Post: 6th February 2006, 10:09 PM -
Spokeshaves - Low Angle or not low angle, that is the question
By Slavo in forum HAND TOOLS - UNPOWEREDReplies: 10Last Post: 6th June 2005, 09:36 AM