Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: A couple of Disstons
-
17th September 2016, 09:20 AM #1Member
- Join Date
- Dec 2011
- Location
- Brisbane
- Age
- 43
- Posts
- 98
A couple of Disstons
Picked up a couple of Disstons for cheap, they are a rough couple (rusty and dusty). Tooth line has a little bit of a wave on one of them, the other has a small curve, should prove plenty of learning potential before I try to
breakfix a more expensive saw.
thumbnail_20160916_163100.jpg
-
17th September 2016 09:20 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
17th September 2016, 09:43 AM #2
Good restoration material.
Innovations are those useful things that, by dint of chance, manage to survive the stupidity and destructive tendencies inherent in human nature.
-
17th September 2016, 10:32 AM #3
Ditto what Rob said and I have to say I have seen and worked on a lot worse than those. Medallion on the wrong side on the lower one. May mean that originally there was no medallion on that saw as the other side should have the large circular depression. It is always interesting/exciting to see if the clean up reveals an etch and consequently clues to what it is.
I will watch with interest for developments.
Regards
PaulBushmiller;
"Power tends to corrupt. Absolute power corrupts, absolutely!"
Similar Threads
-
Stiffening, the next chapter of my questions about Disstons' methods of sawsmithing
By rob streeper in forum Saws- handmadeReplies: 7Last Post: 13th May 2017, 12:24 AM -
Cleaning up two Disstons... or not?
By Luke Maddux in forum ANTIQUE AND COLLECTABLE TOOLSReplies: 2Last Post: 24th February 2015, 10:11 PM -
A Couple Is Better Then None
By Nai84 in forum WOODTURNING - PEN TURNINGReplies: 13Last Post: 13th November 2013, 11:15 PM -
A Couple From The USA
By Nai84 in forum WOODTURNING - PEN TURNINGReplies: 7Last Post: 13th March 2012, 02:15 PM -
Plastic handled Disstons
By kenny_10 in forum HAND TOOLS - UNPOWEREDReplies: 4Last Post: 19th May 2011, 11:27 AM