Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Drive belt for Ryobi DP
-
23rd July 2009, 11:38 AM #1
Drive belt for Ryobi DP
The v belt that drives my Ryobi DP (cr@ppy 5-speed bench model) is very close to completely cactus. It is a 8mm belt and has the marking K26 -660 on it. AFAIK v belts come in A, B, C, and Z profiles. Is there a K profile (26 is the length in inches, I assume and 660 is the same in mm)? Where should I go to try to find a replacement?
Or is there some 5/16" link belt available (the smallest I have found so far is 3/8")?Cheers
Jeremy
If it were done when 'tis done, then 'twere well it were done quickly
-
23rd July 2009 11:38 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
23rd July 2009, 11:35 PM #2
My DP has K 220 and K221 belts , closest section is the z section which is the same thickness at 6mm but 2mm (K is 8mm ,Z is 10mm) wider at the widest point .I reckon the z would be fine and work ok.
I've only seen the poly twist link belt in A section ,the old Brammer belt with the steel studs is a mongrel to use.
I use the poly twist belt on my lathe ,its pretty good stuff. Got it from Blackwoods.
Belt sections are Z,A, B, C, D, SPZ, 3V, SPA, SPB, 5V , SPC, and 8v.
Kev"Outside of a dog a book is man's best friend ,inside a dog it's too dark to read"
Groucho Marx
-
6th August 2009, 11:52 AM #3
I bought a 3/8" Fenner twist link belt from this guy in the US via eBay. The belt arrived yesterday and I installed it on the DP this morning. It was running very nicely when I left for the office, so we will see how it is going when I get home. The 1/16" difference does not seem to be causng any difficulties with the running yet.
Cheers
Jeremy
If it were done when 'tis done, then 'twere well it were done quickly
Similar Threads
-
Drive Belt Replacement
By IanA in forum WOODTURNING - GENERALReplies: 18Last Post: 10th August 2021, 08:39 PM -
ryobi ap13 thicknesser drive belt
By ultimax in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 7Last Post: 27th December 2011, 02:48 AM -
Drive Belt Needed
By widd in forum GENERAL & SMALL MACHINERYReplies: 3Last Post: 11th March 2009, 09:48 PM -
Bandsaw Drive Belt
By Black Ned in forum BANDSAWSReplies: 2Last Post: 2nd February 2008, 06:59 PM