Hi All,
I stumbled across your forum whilst I was looking for either a woodwork space I could rent(with a CNC) or a CNC shop that would do a very small project for reasonable cost.

The project is for a portable MAME box made out of MDF, so basically a bottom , two sides and a larger top with holes for buttons etc.
It is based on this project
http://overt.org/2009/02/22/the-great-wave-mame-box/
Bryan from the above site has sent me the file for the top section in a multitude of options

Anyone know of such a place in Brisbane? Any advice happily recieved as I'm new to the whole CNC world. I converted my coffee table into such a project and hand made and cut the holes and plastic, so hoping not to do so this time, Thanks.

Cheers again,

Steven