Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Bandsaw sled?
-
12th January 2009, 10:48 AM #1SENIOR MEMBER
- Join Date
- Feb 2007
- Location
- Adelaide
- Posts
- 595
Bandsaw sled?
Yeterday I discovered I had made a batch of small tenons a couple of milemetres too long. Simple fix, just set the fence on the bandsaw and dock off the bits using the mitre gauge. I soon discovered that the little bits were carried down through the hole in the bandsaw insert, some pinged off into the shed but one bit jammed between my blade and the roller guides and brought my saw to an abrupt halt. The width of the hole in the insert is about 10mm wide to allow for clearance during table tilt.
My thought is to make a docking sled using the mitre gauge slot. This will have minimum clearance for the blade and will stop offcuts dropping through into the works. Before I go ahead does anyone have any suggestions or comments please.
-
12th January 2009 10:48 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
12th January 2009, 04:47 PM #2Deceased
- Join Date
- Jun 2003
- Location
- ...
- Posts
- 7,955
Similar Threads
-
Sled
By Bob38S in forum TABLE SAWS & COMBINATIONSReplies: 11Last Post: 28th March 2008, 11:33 AM -
Table saw sled
By lubbing5cherubs in forum WOODTURNING - PEN TURNINGReplies: 31Last Post: 30th May 2007, 09:28 PM -
Bandsaw Resaw sled
By Peter36 in forum TIMBERReplies: 5Last Post: 28th December 2005, 07:45 PM -
Sled building
By oldww in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 15Last Post: 27th October 2005, 09:54 PM -
sled or such for bandsaw resawing 12in + logs?
By Wild Dingo in forum BANDSAWSReplies: 10Last Post: 22nd August 2005, 04:45 PM