Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 16 of 16
Thread: calibrate machinist level
-
13th September 2012, 02:48 PM #16
Hi Mike,
6" is fine, it's sensitivity that's the important factor, if you want a quality level, i'd be looking at a Wyler like one of these, Swiss Quality Discount
As far as calibration goes, most of the time you'll only use the level at one point, that is close to zero ( perfectly level), linearity at points away from zero is hard to measure unless you have a pretty good metrology setup.
Regards
Ray
-
13th September 2012 02:48 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
Similar Threads
-
want to be a machinist for a job
By xXvapourXx in forum METALWORK FORUMReplies: 28Last Post: 27th August 2011, 07:29 PM -
The dishonest machinist
By neksmerj in forum METALWORK FORUMReplies: 11Last Post: 7th March 2011, 08:44 PM -
Stanley Rule and Level Co no93 Spirit Level
By Sapling in forum HAND TOOLS - UNPOWEREDReplies: 2Last Post: 24th May 2010, 07:23 PM