Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
26th June 2018, 08:30 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,478
Electrical help? Connecting a servo with surge suppressor
Hi all so I got this picture in the Chinese manual for my servos that are going on my HM-46 mill:
img upload
Was hoping someone could help me select a contactor online I could buy. Looks like I need a contactor with surge suppression so I started looking.... 240v should do it with a 24V DC coil.
I got 4000 to go through on RS Online - https://au.rs-online.com/web/c/autom...Term=contactor
Not sure on the differences between them all but will this one do the job? It's the cheapest at 24V DC coil - https://au.rs-online.com/web/p/contactors/7061106/
Datasheet says size "S00" and I looked for a surge suppressor and this one is for "3RT2" but size S2 - https://au.rs-online.com/web/p/conta...ories/1271495/
I found some more here and was hoping someone could point me in the right direction it's a bit confusing with all the specs on voltage on the datasheets - https://au.rs-online.com/web/c/autom...434,4294639534
My servos are three 3 750W and I also have one 1.8kw servo (spindle).
Hoping the breaker is a fair bit easier to find.
Thanks for any help.
Read the full thread at metalworkforums.com...
-
26th June 2018 08:30 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Triton TR001 Surge Problem
By Mike_R in forum ROUTING FORUMReplies: 14Last Post: 21st September 2011, 11:37 PM -
toy garage/servo
By joeyjons in forum TOY MAKINGReplies: 11Last Post: 26th November 2010, 04:05 PM -
Surge protection
By whitewood in forum COMPUTERSReplies: 9Last Post: 12th March 2009, 07:54 AM -
Electrical help connecting a motor - where should these go?
By colinshannon in forum METALWORK FORUMReplies: 51Last Post: 17th April 2007, 05:03 PM