Thread: power grip jaws

Originally Posted by Sawdust Maker

There seem to be two sets of power grip jaws
those that fit a titan and those that fit a SN2
not sure about relative sizes but think the titan set are bigger

Not sure I have both SN2 and Titan on the SN2 i have a set of power grip jaws. It may depend on the number of holes in the Titan. With mine one has two and the has three.

There was 2 sets of power grip jaws.

The 100mm size compatible the the supernova 2 chucks with 2 screws and the 130mm size suitable for the Titan chuck with 3 screws.

You could fit the 130mm ones onto the supernova as the 2 screw holes lined up, you just had to be carefull not to put too big a peice in the chuck and it is seated properly on the face of the jaws ans went as deep as possible into the jaws with out touching the bottom. Also only open the jaws 6-8mm.

My Titan came with 100mm power grip jaws with 2 holes I am sure I bought it from Gary Pye about 6 years ago. The chuck has 3 holes.
Regards Rod.

Originally Posted by Jim Carroll

There was 2 sets of power grip jaws.

The 100mm size compatible the the supernova 2 chucks with 2 screws and the 130mm size suitable for the Titan chuck with 3 screws.

You could fit the 130mm ones onto the supernova as the 2 screw holes lined up, you just had to be carefull not to put too big a peice in the chuck and it is seated properly on the face of the jaws ans went as deep as possible into the jaws with out touching the bottom. Also only open the jaws 6-8mm.

Thanks Jim!