Anyone made a pen mandrel??
Got plans or drawings, simple DIY version??
Printable View
Anyone made a pen mandrel??
Got plans or drawings, simple DIY version??
Check out Rick Herrel in the International Association of Penturners website, saw one there last night. Basically a round steel bar that fits inside the tube, machined with a small flat and a bit of smaller round bar sitting in the machined flat.
Regards
Kryn
Are you talking a plain mandrel, eg nominal 7mm?
Or are you talking about a closed end pen mandrel?
Why bother trying to re-invent the wheel ???
a normal mandrel can be brought for less than $20.00 and. Closed end one can be sourced for not a great deal extra, just gotta ask the right question.
HazzaB
Yup, at least two.
The first was a bit of rod, with tape wrapped around it to make the diameter right, and the second is shown here
https://www.woodworkforums.com/f69/ma...4/#post1047719
Cheers,
Andrew