Search:

Thank you Pete your advice is helpful, I will follow it up asap.
Regards Robert

Thank you for the prompt reply concerning the nail spacing, my sheets 1200x2400mm dont have a tonge and groove, but I suppose that a track of no nails along the edge will have to suffice. I will also...

Hi Chaps
I'm about to fit six 19mm x 2400x1200 form ply sheets on 8x2 joists as a raised floor to a shed like structure.
Question, what size/type/spacing nails to use and if a "no nails" type of...

I am building a small hut and am stuck with the material for the floor.
The area is prone to termites, they are eating the old hut, I have the
concrete columns set with beams and joists in...

Thanks Jill for your interest, attached is a very rough sketch of the setup, suggestions would be most welcome

thanks
Robert


QUOTE=JillB;1060318]Can you please send us a diagram of the...

121470

Hi Mr Calm
Thanks for the reply just needs a little explaining for this dumb cove.
Attached is rough sketch of configuration, if you could modify the drawing showing what it should be, I...

Gosh you chaps are really on the ball , I have only just posted the question
Now I have had this working in the past before I put in the T piece for the priming. Not sure though how I did it. I...

I have a question about pumps on domestic water tanks.
My tank is in the ground so my pump is on the surface above the tank, I wish to pump out the water but there is no flow via the pump because of...