Search:

Tag: ideas/links

Search: Search took 0.03 seconds.

Fraction marking punch sets - do these exist?

Started by variant22, 2nd October 2013 12:06 PM

2 Pages •

1 2

$1/2, 1/4, 1/8, bit, collet, compared, exist, figure, fraction, fractions, gear, holder, ideas/links, imperial, letter, marking, punch, scale, searching, set, sets, sizes, standard, terms, track, transfers, wrong$
- Replies: 23
- Views: 3,083
Last Post By:

Last Post: 5th October 2013 08:50 PM

by pipeclay

Forum:
METALWORK FORUM

Results 1 to 1 of 1

All times are GMT +11. The time now is 04:29 AM.

Search Engine Optimisation provided by DragonByte SEO v2.0.42 (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Copyright © U-Beaut Enterprises 1999 - 2016. All rights reserved.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.

Search:

Search: Search took 0.03 seconds.

Fraction marking punch sets - do these exist?