Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Need help trueing ML392
-
1st March 2007, 10:52 AM #1Senior Member
- Join Date
- Jul 2006
- Location
- Canberra
- Posts
- 296
Need help trueing ML392
My ML392 is way out of whack. What I'm doing to try and fix it is:
1. get the outfeed table right across the table measuring against the blades. The means changing the lower adjustment bolt up or down to get it OK across the table.
2. There seems to be no way of adjusting the outer end of the outfeed table up or down (pitch), hence it has to be left the way it is and so the pitch of the outfeed table is now the pitch that the infeed will have to be adjusted to (true?)
3. adjust the infeed table in the same way as 1 so that it's level across the table against the blades.
4. now, after 1-3 the near-blade part of the infeed right is correct against the outfeed and the blades, but the pitch of the outfeed is stuffed: putting a straight edge from the outer of the outfeed table to the outer of the infeed table shows the infeed is lower (at the outer end) by about 15mm! Now my problem is I can't see anyway to adjust the pitch (ie. raise the outer end only) of the infeed table. There's a couple of strange bolts with hex adjusters (?) on the outside/front of the infeed table and I thought these could be use to adjust. However, they're fairly far forward making it less clear they can adjust the outer while leaving the inner part of the table stationary, and besides, there's also two what look like lugs which seem to make these bolts & hex dudes impossible to use to adjust anything anyway. With the swing mechanism of the tables, there doesn't seem to be anywhere to shim either.
So I'm stumped - can anyone assist?
Rob
-
1st March 2007 10:52 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
1st March 2007, 11:01 AM #2
Hi Rob,
if you haven't checked already, the best place for info on the 392 is http://www.woodworkforums.ubeaut.com...ad.php?t=14610
If the answer isn't there then we can add it to the thread when you get one so please repost there. Thanks
|^^^^^^^^^^^^^^| |^^^^^^^^^^^^^| ||
| .....BIGGER ......._____| | ...BEER TRUCK.....| ||´|";,___.
|_..._...__________/====|_..._..._______==|=||_|__|..., ] -
"(@)´(@)"""´´" *|(@)(@) "(@)´(@)"""´´"*|(@)(@)****(@)
Similar Threads
-
The ongoing saga of the ML392
By BobR in forum HAND TOOLS - POWEREDReplies: 231Last Post: 14th November 2011, 08:52 PM -
ML392... Should I - Shouldn't I?
By DanP in forum POLLSReplies: 19Last Post: 22nd March 2005, 04:29 PM -
Yet another ml392 question
By Leif... in forum HAND TOOLS - POWEREDReplies: 7Last Post: 30th December 2004, 02:23 AM -
Question for TSC10HB and ML392 owners.
By DanP in forum WOODWORK - GENERALReplies: 4Last Post: 12th October 2004, 12:25 PM