Search:

Tag: anout

Search: Search took 0.00 seconds.

  1. Lathe motor lost its grunt

    Started by orraloon, 15th May 2013 08:58 PM
    1hp, advise, anout, bearings, blank, bowl, cuts, dia, electrical, estimated, expert, grunt, headstock, hot, hours, induction, john, largish, lathe, lost, modest, motor, roughing, spins, stall, taking, torque, turnings, warm 1 Attachment(s)
    • Replies: 11
    • Views: 2,762
    Last Post: 19th May 2013 03:22 AM
    by nalmo  Go to last post

    Forum:
    WOODTURNING - GENERAL

  2. Veneer a guitar

    Started by JohannP, 20th August 2012 04:16 PM
    anout, answer, binding, bit, bits, building, carved, curved, flat, forget, guitar, haha, info, mockingbird, paint, picture, pictures, pnly, question, rich, shape, shaped, sounds, surfaces, top, uneven, upload, veneer
    • Replies: 5
    • Views: 2,159
    Last Post: 21st August 2012 07:17 PM
    by jeffhigh  Go to last post

    Forum:
    MUSICAL INSTRUMENTS

  3. 25 degree bevel??

    Started by mattym83, 11th October 2009 09:42 AM
    accurate, anout, bevel, degree, easiest, edge, edges, hand, ideas, inch, matt, plane, routing, table, thinking, top, wide
    • Replies: 4
    • Views: 1,654
    Last Post: 11th October 2009 04:49 PM
    by mattym83  Go to last post

    Forum:
    WOODWORK - GENERAL

  4. EC's 335

    Started by craigb, 21st February 2007 09:18 PM
    335, anout, binding, company, cream, ecs, file, forum, found, gibson, guitar, guy, instrument, mins, musical, play, pretty, quality, reproducing, runs, vid, video, watching, woodwork
    • Replies: 1
    • Views: 2,451
    Last Post: 3rd March 2007 08:03 PM
    by larkim  Go to last post

    Forum:
    MUSICAL INSTRUMENTS

  5. A story anout pens

    Started by Phil Spencer, 9th April 2006 11:07 AM
    anout, blanks, cat, commissioners, container, cops, cream, eek, found, habit, ice, infringement, late, left, liquid, night, payers, pee, peed, pens, phil, police, received, slow, smelly, start, story, sucking, traffic, true
    • Replies: 7
    • Views: 1,965
    Last Post: 12th April 2006 09:13 AM
    by Phil Spencer  Go to last post

    Forum:
    WOODTURNING - GENERAL

Results 1 to 5 of 6